Main Article Content
In this study, the Taguchi technique was used to investigate the impact and optimization of machining parameters on vibration in turning operations. Experiments were carried out with varying cutting speeds, victual rates, and cutting depths. In this analysis, two distinct Kevlar materials with the same ratio as Shim are used. An orthogonal array, the signal-to-noise (S/N) ratio, and analysis of variance (ANOVA) were used to investigate performance characteristics in the turning of oil-hardened non-shrinking steel using SNMG 120408 EN - TMR insert cutting implements.
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.